Vision prototype photo

Vision prototype photo
This is the Vision prototype designed/built by Steve Rahm in USA. and still being supported by Pro Composites Ltd. in USA. The aircraft is a 2 seat side by side, scratch built from a series of manuals. Built entirely of fiberglass and carbon cloth material the builder needs to know or learn some of the easy basics of composite construction. Building began Feb. 1998 in my spare time with 7 years where no building was possible. Building Hours at February 28, 2022: 4248.--------------------------------------------------------------------------------------------------------------------------------Some short videos of flights are at: https://www.youtube.com/channel/UCfxJXIwvmfNlNF3gwplFw7Q

Saturday, October 23, 2021

August September & October Wiring and more Wiring

 October 23 2021, Not much more in the way of photos as the wiring is a huge job.  Thankfully I have made loads of schematic diagrams to keep it all in order.  On the sub panel 18 inches ahead of the main panel from left to right are the Dynon Com Radio, screw terminal strip, Dynon Engine Monitor and Dynon Transponder.


I am keeping the panel to the bare minimum and that is thanks to the design of the Dynon equipment.

I made up my own wiring harness for the Intercom, Radio and Transponder units.  This was probably the most complex wiring of it all.

Next two photos are my wingtip wiring all in place with the nav/strobe power box, also the coil of aluminum for fuel tank air vent and overflow.

My wing tip installed and my Nav/Strobe unit tested.

Below is my new next door hangar neighbour Chris's Acro Sport II which he purchased mostly finished and then completed and upgraded to his liking.



at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)