October 23 2021, Not much more in the way of photos as the wiring is a huge job. Thankfully I have made loads of schematic diagrams to keep it all in order. On the sub panel 18 inches ahead of the main panel from left to right are the Dynon Com Radio, screw terminal strip, Dynon Engine Monitor and Dynon Transponder.
I am keeping the panel to the bare minimum and that is thanks to the design of the Dynon equipment.
I made up my own wiring harness for the Intercom, Radio and Transponder units. This was probably the most complex wiring of it all.
Next two photos are my wingtip wiring all in place with the nav/strobe power box, also the coil of aluminum for fuel tank air vent and overflow.
My wing tip installed and my Nav/Strobe unit tested.
Below is my new next door hangar neighbour Chris's Acro Sport II which he purchased mostly finished and then completed and upgraded to his liking.
