Vision prototype photo

Vision prototype photo
This is the Vision prototype designed/built by Steve Rahm in USA. and still being supported by Pro Composites Ltd. in USA. The aircraft is a 2 seat side by side, scratch built from a series of manuals. Built entirely of fiberglass and carbon cloth material the builder needs to know or learn some of the easy basics of composite construction. Building began Feb. 1998 in my spare time with 7 years where no building was possible. Building Hours at February 28, 2022: 4248.--------------------------------------------------------------------------------------------------------------------------------Some short videos of flights are at: https://www.youtube.com/channel/UCfxJXIwvmfNlNF3gwplFw7Q

Sunday, May 30, 2021

May progress

May and June not much to report.  The Rudder and Elevator were installed on the airplane and all of the bolts and nuts of the proper sizes installed. 

The tail wheel install was completed with all bolts-nuts and safety wired.  I made up two interface stainless connector cables to tie in the tail wheel steering springs.



at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)